Plagued by misalignment problems with your non-contact safety swithes in you equipment safety circuits?
Forced to open and close your equipment access doors to determine which non-contact switch is not closing?
Hard to determine which non-contact switch has failed in your equipment safety circuits?
If so, Rockwell Automation and Roden Electric have a solution for you. One that will solve the problems incurred when applying non-contact
safety switches on your equipment.
Introducing the SensaGuard family of Non-Contact Coded Safety Interlock Switches. The SensaGuard family is intended for machine
guarding with part or full body access. It is particularly suited for machines where multiple access doors must be monitored.
|
| |
FEATURES
- RFID coding
- High tolerance to misalignment
- Output/Diagnostic LED on the sensor
- IP69K Wash down
- Mounting adjustability
- Uses standard proximity mounting brackets (Right angle bracket, clamp bracket)
|
Featuring the latest generation of RFID technology for coding and inductive technology for sensing, SensaGuard's large sensing range and tolerance
to misalignment is a cost-effective solution that is ideally suited for a wide range of industrial safety applications.
SensaGuard switches can be connected to a standard safety relay such as the MSR126, MSR127, MSR200/300 family, Smart Guard, and Safety I/O blocks.
There are multiple actuator sizes for large sensing distances, typically 15-25mmn. The switches have an IP69K environmental rating suitable for
washdown areas. Each switch also has short circuit and over voltage protection, LED's to indicate door status, and troubleshooting with 2 safety
PNP outputs and 1 auxillary PNP output.
|
| |
FEATURES
- RFID coding
- IP69K Washdown rating
- High tolerance to misalignment
- Output/Diagnostic & Margin indication LED on the sensor
- Wire 30 switches in series
- Mounting adjustability
- Margin indication / Magnetic Hold features
|
Troubleshooting SensaGuard is fast and easy. Each switch is connected in a series and the circuit is provided with 24VDC. The outputs
from teh switch circuit goes to the appropriate safety relay. Each switch that has proper alignment will show a solid green LED. A unit
that is misaligned or has a fault will show a blinking red LED. Units downstream from teh faulty unit will show blinking green LED's. You
can tell at a glance by walking around your equipment which switch is c ausing the problem. This saves time and money in your facility's
operation
|
| |
FEATURES
- RFID coding
- High tolerance to misalignment
- Output/Diagnostic & Margin indication LED on the sensor
- Wire 30 switches in series
- IP69K Washdown rating
- Mounting adjustability
- Uses standard proximity mounting brackets (Right angle bracket, clamp bracket)
|
For further information on the SensaGuard product family, please contact your local Roden Electric.
|
